Average Reviews:
(More customer reviews)I have been a long standing AT&T DSL subscriber in Texas. When my seemingly ancient 2Wire Homeportal 1000 finally gave way after ~7 years of use (aka, died), I called AT&T and assumed they would send a replacement DSL modem post haste. Au contraire. Said I was on my own, and was frankly pretty shocked as I am a big AT&T customer. I use an Apple Airport Extreme wireless network (5 wireless distribution nodes) and did not want/need to purchase the latest 2Wire WIFI device at over $200, but I also wanted more than one ethernet port on the device. BTW - I ran the HomePortal in Bridge Mode.
The D-Link DSL-2540B fit the bill but I was hesitant as I needed to configure the ne modem in Bridge or Bridging mode as I use PPPoE to connect to the net from my Airport Extreme base station. I found the following config info on the net (see below) while researching various solutions, and when my DSL-2540B today, I was up and running within 10 minutes.
Performance and connectivity have been great.
AT&T Bridge Mode Settings
Connect your computer directly to the D-Link. Use a cable, as Wi-Fi masochism is beyond the scope of this document. Browse to http://192.168.1.1/ in the browser of your choice. If your system has assigned itself a 169.mumble address, you will first need to manually assign your computer an IP address like 192.168.1.5, a subnet mask of 255.255.255.0, and a default gateway of 192.168.1.1 to do so.
You should be challenged for a username and password to proceed. By default these are both set to "admin" and you really ought to change this at some point.
You should be presented with a Home / Wizard screen. Un-check the box labeled "DSL Auto-connect." This will allow you to specify the VPI and VCI for your connection. For most ISPs in the AT&T ILEC footprint, this will be 0 and 35 respectively. Click Next.
You should be prompted to set the connection type. Select the radio button labeled "Bridging" and the pull-down menu option labeled "LLC/SNAP-BRIDGING." Click Next.
You will be presented with the Device Setup screen. The default settings will suffice for most home use. Click Next.
You will be presented with the wireless configuration screen. If you wish to disable wireless for some reason (and should have bought at 2320B instead), un-check the box labeled "Enable Wireless." Click Next.
You will be presented with a summary of your configuration. Read it carefully to ensure that it understood you correctly, then click the button labeled "Save / Reboot." The DSL-2640B will restart, after which you should have Internet connectivity.
Click Here to see more reviews about: D-Link DSL-2540B ADSL2/2+ Modem with 4-Port Ethernet Router TR067/069
The D-Link ADSL2/2+ Modem with 4-Port Ethernet Router (DSL-2540B) is a 2-in-1 device that combines the function of a DSL modem and 4-port 10/100 Ethernet router. The DSL-2540B supports the latest ADSL2/2+ standards to provide higher performance (up to 24Mbps* downstream and 3.5Mbps* upstream) and longer reach from your Internet Service Provider’s (ISP) Digital Subscriber Line Access Multiplexer (DSLAM). You can also create a wired network to share your high-speed Internet connection, documents, photos, music, videos, printers, and Network Attached Storage (NAS).
Get 37% OFF
0 comments:
Post a Comment